Recommendation: PPH for Panel Design
Posted: Thu Sep 26, 2024 3:58 pm
Apologies if I'm not meant to do this.
Recently, I needed to get a panel cut for my Taylor Mono, but I have no experience in CAD software myself.
I wanted to share that I had a really good experience using PeoplePerHour to find a CAD designer offshore who could turn my PDF design / sketch into a DXF file.
The whole thing cost me £35 and was turned around in under a day. They even spotted a couple of tiny measurement errors I'd made and were incredibly thorough.
So, if you are looking to replace a panel at any point I would strongly recommend looking into PPH as an option to save a bit of time and money. There are quite a few people on there who can do the work and a quick search will find recommendations.
My panel is now with the local laser cutter and I'm looking forward to physically holding a layout of my own design!
Recently, I needed to get a panel cut for my Taylor Mono, but I have no experience in CAD software myself.
I wanted to share that I had a really good experience using PeoplePerHour to find a CAD designer offshore who could turn my PDF design / sketch into a DXF file.
The whole thing cost me £35 and was turned around in under a day. They even spotted a couple of tiny measurement errors I'd made and were incredibly thorough.
So, if you are looking to replace a panel at any point I would strongly recommend looking into PPH as an option to save a bit of time and money. There are quite a few people on there who can do the work and a quick search will find recommendations.
My panel is now with the local laser cutter and I'm looking forward to physically holding a layout of my own design!